Hardware Installation
2.10.3 Serial Devices (COM1/COM2)
To support serial devices, insert the
serial device connector into the serial
port on the bracket. Plug in the serial
port
bracket
connectors
onto
the
appropriate onboard connectors.
The
COM1 connector is marked CN5 and the
COM2 connector is marked CN6 on the
system board.
2.10.4 Floppy Disk Drives
Connect the drive cable onto the floppy
disk drive connector marked CN10 on
the system board. See section 1.1 for
the location of the connector. Refer to
the figure on how to connect the cables.
2-18