Front-Panel Switches And Leds - AOpen AP5V User Manual

Hardware Installation
Secondary IDE Connector
The secondary IDE connector is marked
CN11 on the board. This connector also
supports two IDE devices. You may
connect your additional IDE HDD or CD-
ROM drive to this interface. To install an
IDE CD-ROM drive, connect the CD-
ROM drive connector to the interface
master port.
If you have more than two IDE hard
disks, connect your third IDE hard disk to
the master port. Then connect your CD-
ROM drive to the slave port.

2.10.7 Front-panel Switches and LEDs

HDD LED
The HDD LED connector is marked
CN16 on the board. Plug the HDD LED
socket onto this four-pin connector. See
the figure.
2-20