Table of Contents
Advertisement
USB 2.0 Connectors
This motherboard provides eight USB 2.0 ports to connect USB devices such as
mouse, keyboard, modem, printer, etc. There are four ports on the back panel.
You can use proper cables to connect Front USB connector to USB modules or
chassis front panel.
Pin 1
Pin 1
1
+5V
+5V
SBD6-
SBD7-
SBD6+
SBD7+
GND
GND
KEY
NC
USB 2.0 Connector
10/100 LAN onboard
On the strength of 10/100 LAN controller on board, this motherboard provides
10/100Mbps Ethernet for office and home use. The Ethernet RJ45 connector is
located on the top of USB connectors. The right hand side LED indicates link
mode; it lights in yellow when linking to network. The left hand side LED indicates
the transfer mode and will light in green when data is transferring at 100Mbps
(never lights while at 10Mbps). To enable or disable this function, you may simply
adjust it through BIOS. To enable LAN wakeup function, you have to set the "Wake
on PCI Card" enable in the BIOS "Power Management Setup" section.
Speed LED (Left)
Green 100Mbps
ACT LED (Right)
Yellow
Pin 1
Front Audio Connectors
If the housing has been designed with an audio port on the front panel, you'll be
able to connect onboard audio to front panel through this connector. By the way,
please remove 5-6 and 9-10 jumper caps from the Front Audio Connector before
connecting the cable. Please do not remove these 5-6 and 9-10 yellow jumper
caps if there's no audio port on the front panel.
Pin 1
1 2
AUD_GND
AUD_MIC
AUD_VCC
AUD_MIC_BIAS
AUD_FPOUT_R
AUD_RET_R
NC
KEY
AUD_FPOUT_L
AUD_RET_L
Front Audio Connector
Serial ATA Connectors
To connect a serial ATA disk, you have to have a 7-pin serial ATA cable. Connect
two ends of the serial ATA cable to the serial ATA header on the motherboard and
the disk. Like every other traditional disk, you also have to connect a power cable.
Please be noted that it is a jumper free implement; you don't need to set jumpers
to define a master or slave disk. When serial ATA hard disks are installed on serial
ATA ports, the one connected on SATA1 will be set as the first boot device
automatically. Please note that it doesn't support Hot-Plug in function.
SATA1 SATA2
Advertisement
Table of Contents
