Multifunction Connector
The multifunction connector is a 20-pin
connector marked CN14 on the board.
Attach the green mode LED, keylock,
reset switch, turbo switch, and turbo LED
connectors onto the corresponding pins
as shown in the figure.
Some housings have a five-pin connector
for the keylock and power LED.
Other housings may have a 12-pin
connector. If your housing has this type
of connector, plug it onto CN14 as shown
in the following figure. Make sure that
the red wire of the connector connects to
pin 11.
Hardware Installation
Speaker
Power LED
Reset
Break Switch Green Mode LED
( Turbo Switch ) ( Turbo LED )
Speaker
Keylock & Power LED
Reset
Break Switch
( Turbo Switch )
Ground
Reset
Res-VCC
Speaker
Break Switch
( Turbo Switch )
Ground
Keylock
Green Mode LED
( Turbo LED )
Keylock
Ground
VCC
2-21