Pentair THS Series Installation And User Manual page 26

STEP 3: Installation of Controller Tubing
Connect length of tubing from supply source
(water or compressed air) to the inlet side of
the regulator. Please note, the water source
must be able to supply water at a pressure
of 35 psi minimum.
Connect length of tubing from the outlet side of
the regulator to the inlet end of the check valve.
Please note the direction of the flow arrow on
the check valve. It should be pointing away
from the regulator.
Connect length of tubing to open end of the
check valve. Connect quick connect tee to end
of tube.
Connect tubes from the quick connect tee to
back of the gauge panel assembly as shown in
picture. One end should be connected to the
center fitting on the multiport valve. The other
end should be connected to the multiport
pressure gauge
Diaphragm Valve Face Piping Kit Installation Manual Pg. 25 of 52
5/31/12 Rev. F