Table of Contents
Advertisement
Connect tubes into respective fittings on the back
of the multiport valve enclosure. Connect a tube
from remaining quick connect fitting and connect
to drain.
Connect the four wires from the rear of the
multiport valve enclosure to the rear of the
automatic controller enclosure. Each wire has a
different style pin connector and can only
connect to one of the sockets on the back of the
automatic controller enclosure.
This completes the installation of the automatic backwash controller for dual tank systems. Please
see Owner's/Operator's Manual for automatic controller set up and operation.
Diaphragm Valve Face Piping Kit Installation Manual
Pg. 34 of 52
5/31/12
Rev. F
Hide quick links:
Advertisement
Table of Contents
