Table of Contents
Advertisement
STEP 2A: Attach Gauge Panel to Pipe
Insert notched end of pipe clamps into the
channel of the controller supports. Attach the
gauge panel assembly to the waste extension
(see picture). Slide remaining pipe clamps into
the channels of the controller supports. Use
the nuts and bolts supplied to tighten the
clamps on to the pipe.
STEP 2B: Attach Gauge Panel to Flange
Attach the gauge panel assembly to flange
(see picture). Insert isoplast bolts through the
bottom holes of the gauge panel and top holes
of the flange. Use the isoplast nuts to tighten
in place.
**Please note that the setup shown is for a 6"
flanged connection. The flange connection
plate may be modified for use on a 4" or 8"
flanged connection.
Diaphragm Valve Face Piping Kit Installation Manual
Pg. 21 of 52
5/31/12
Rev. F
Hide quick links:
Advertisement
Table of Contents
