Table of Contents
Advertisement
Connect tubes to each side of the quick connect
tee. Connect one tube to the multiport pressure
gauge and the other to the center fitting on the
multiport valve (see picture).
Drill and tap for ¼" NPT hole on the influent and
effluent pipes from the filter system (see
schematic diagram in Appendix B). Install quick
connect fittings into holes. Be sure to use pipe
thread sealant tape on the threads. Install into
each fitting a length of 3/8" OD tubing. Connect
a quick connect tee on to the other end of each
tube. Connect two smaller pieces of tubing into
each end of the tee and connect to the rear of the
automatic controller enclosure as shown.
Connect lengths of tubing into the quick connect
fittings on top of the valve cover. Join the two
tubes with a quick connect tee as shown in the
picture.
Diaphragm Valve Face Piping Kit Installation Manual
Pg. 29 of 52
5/31/12
Rev. F
Hide quick links:
Advertisement
Table of Contents
