Table of Contents
Advertisement
3 Backwash Controller Installation
NOTE: This section covers the installation of semi-automatic and automatic backwash
controllers for single tank and dual tank systems.
3.1 Semi-automatic Controller (CM200) - Single Tank Installation
The single tank semi-automatic controller kit consists of the following:
(1) Controller gauge panel
(2) 3/8" OD tube quick connect tees
(3) 3/8" OD x ¼" MNPT quick connect
fittings
(1) Check valve w/ fittings
(100 ft) 3/8" OD polyethylene tube
Semi-automatic controllers may be mounted 1 of 2 ways and is system specific. Mounting
methods are "pipe mounted" or "flange mounted". For pipe mounted systems, verify the
mounting accessories shown below and refer to steps 1 and 2A for installation. For flange
mounted systems, refer to step 2B for installation.
Pipe mounting accessories (system specific):
(2 pr.) *Mounting brackets and hardware
(2) Controller supports
(2) Isoplast bolts
(2) Isoplast nuts
* Mounting brackets will vary based on the filter system
being used. Brackets supplied will fit typical waste pipe
size of 6". Please note that Brackets are available for 4"
or 8" pipe diameter. If required, these can be ordered
through a Stark distributor.
Verify that all parts listed above were supplied before
beginning installation. Replacement parts can be
ordered through a Stark distributor.
Diaphragm Valve Face Piping Kit Installation Manual
5/31/12
Pg. 19 of 52
Rev. F
Hide quick links:
Advertisement
Table of Contents
