D Transmitting A Remote Monitor Call - Icom iF4261DT Operating Manual

Previous view
7
NXDN™ OPERATION
Transmitting a call (Continued)

D Transmitting a Remote Monitor call

You can send a signal that requires the target station
to transmit the microphone audio.
NOTE: When the call type is "Talkgroup," the
Remote Monitor call cannot be sent.
<Menu operation>
TIP: The Portable type transceiver's operations are
described in red. And the Mobile type transceiver's
operations are described in blue.
LThe common operations are in black.
(MENU > CONTACT > REMOTE MONI)
1. Push [Menu] to display the Menu screen.
• "CONTACT" is selected.
Portable
CONTACT
BACK ENT
Mobile
M E N U
C O N T A C T
2. Push [P1](ENT) or [P2].
• The current call type is briefly displayed, then the
Contact menu screen is displayed.
LTo change the call type, see page 7-3.
3. Push [P2](Ω) or [P3](≈)
select the destination ID, then push
[P2].
Portable
CONTACT 1 1
Station1
BACK ENT
Mobile
C O N T A C T
S t a t i o n 1
TIP: If "DIRECT DIAL" is selected, you can
manually enter a target ID. See page 7-32 for
details.
or [ΩP3] or [P4≈] to
[P1](ENT) or
1
4. Push [P2](Ω) or [P3](≈)
select "REMOTE MONI."
Portable
Station1
REMOTE MONI
BACK TX
Mobile
S t a t i o n 1
R E M O T E
5. Hold down [P1](TX)
transmit the Remote Monitor call.
• "REM TX" is displayed while transmitting.
L When the call type is "Talkgroup,"
disabled.
6. When an acknowledgment is received, "REM
ACK" is displayed.
L "REM FAIL" is displayed if the target station does not
send back an acknowledgement.
7-24
or [ΩP3] or [P4≈] to
M O N I
or [P2] for 1 second to
[P1](TX) or [P2] is