D Transmitting A Message - Icom iF4261DT Operating Manual

Previous view
7
NXDN™ OPERATION
Transmitting a call (Continued)

D Transmitting a Message

You can transmit a message of up to 100 characters.
The transceiver has 10 memories to save messages.
<Menu operation>
TIP: The Portable type transceiver's operations are
described in red. And the Mobile type transceiver's
operations are described in blue.
LThe common operations are in black.
Using the Contact menu:
(MENU > CONTACT > MESSAGE)
1. Push [Menu] to display the Menu screen.
• "CONTACT" is selected.
Portable
CONTACT
BACK ENT
Mobile
M E N U
C O N T A C T
2. Push [P1](ENT) or [P2].
• The current call type is briefly displayed, then the
Contact menu screen is displayed.
LTo change the call type, see page 7-3.
3. Push [P2](Ω) or [P3](≈)
select the destination ID, then push
[P2].
Portable
CONTACT 1
TG1
BACK ENT
Mobile
C O N T A C T
T G 1
TIP: If "DIRECT DIAL" is selected, you can
manually enter a target ID. See page 7-32 for
details.
4. Push [P2](Ω) or [P3](≈)
select "MESSAGE," then push
or [ΩP3] or [P4≈] to
[P1](ENT) or
1
or [ΩP3] or [P4≈] to
[P1](ENT) or [P2].
Portable
TG1
MESSAGE
BACK ENT
Mobile
T G 1
M E S S A G E
5. Push [P2](Ω) or [P3](≈)
"PRE DEFINED," then push
Portable
MESSAGE
PRE DEFINED
BACK ENT
Mobile
M E S S A G E
P R E D E F I N E D
• Enters the Message Selection mode.
TIP: If "WRITE NEW" is selected, you can
manually enter a message. See page 7-16 for
details.
6. Push [P2](Ω) or [P3](≈)
select a message.
Portable
MESSAGE
Hello!
BACK TX
Mobile
M E S S A G E
H e l l o !
7. Hold down [P1](TX)
message to the selected station or Talkgroup.
• "MSG OK" is displayed after receiving an
acknowledgement from the target station.
• "MSG FAIL" is displayed if the target station does not
send back an acknowledgement.
7-12
or [ΩP3] or [P4≈] to select
[P1](ENT) or [P2].
or [ΩP3] or [P4≈] to
1
or [P2] to transmit the