Icom iF4261DT Operating Manual page 65

Previous view
7
NXDN™ OPERATION
Transmitting a call
D Transmitting a Status message (Continued)
<Key operation>
Using [Digital Button]:
1. Push [Digital Button] to enter the Application
Selection mode.
• The current call type is briefly displayed, then "VOICE"
is displayed.
LTo change the call type, see page 7-3.
2. Push [CH Up] or [CH Down] to select "STATUS,"
then push [Digital Button].
Portable
STATUS
MENU DIGI ZONE SET
Mobile
S T A T U S
3. Push [CH Up] or [CH Down] to select a status
message, then push [Digital Button].
Portable
STATUS
TX Status 01
MENU DIGI ZONE SET
Mobile
S T A T U S
T X S t a t u s
• Enters the Destination ID Selection mode.
4. Push [CH Up] or [CH Down] to select the
destination ID.
Portable
STATUS
TG1
MENU DIGI ZONE SET
Mobile
S T A T U S
T G 1
0 1
7-10
5. Push [PTT] to transmit the status message to the
selected station or Talkgroup.
• "STAT OK" is displayed after receiving an
acknowledgement from the target station.
• "STA FAIL" is displayed if the target station does not
send back an acknowledgement.