Icom iF4261DT Operating Manual page 80

Previous view
7
NXDN™ OPERATION
Transmitting a call
D Transmitting a Remote Monitor call (Continued)
<Key operation>
Using [Digital Button]:
1. Push [Digital Button] to enter the Application
Selection mode.
• The current call type is briefly displayed, then "VOICE"
is displayed.
LTo change the call type, see page 7-3.
2. Push [CH Up] or [CH Down] to select "REM
MON," then push [Digital Button].
Portable
REM MON
MENU DIGI ZONE SET DIGI
Mobile
R E M M O N
• Enters the Destination ID Selection mode.
3. Push [CH Up] or [CH Down] to select the
destination ID.
Portable
REM MON
Station1
MENU DIGI ZONE SET DIGI
Mobile
R E M M O N
S t a t i o n 1
4. Push [PTT] to transmit the Remote Monitor call.
• "REM TX" is displayed while transmitting.
L When the call type is "Talkgroup,"
disabled.
5. When an acknowledgment is received, "REM
ACK" is displayed.
L "REM FAIL" is displayed if the target station does not
send back an acknowledgement.
Using [Individual]:
1. Push [Individual] to enter the Application Selection
2. Push [CH Up] or [CH Down] to select "REM
3. Push [CH Up] or [CH Down] to select the
4. Push [PTT] to transmit the Remote Monitor call.
[P1](TX) or [P2] is
5. When an acknowledgment is received, "REM
7-25
mode.
• "INDIVIDUAL" is briefly displayed, then "VOICE" is
displayed.
MON," then push [Individual].
Portable
REM MON
MENU DIGI ZONE SET INDV
Mobile
R E M M O N
• Enters the Destination ID Selection mode.
destination ID.
Portable
REM MON
Station1
MENU DIGI ZONE SET
INDV
Mobile
R E M M O N
S t a t i o n 1
• "REM TX" is displayed while transmitting.
L When the call type is "Talkgroup,"
disabled.
ACK" is displayed.
L "REM FAIL" is displayed if the target station does not
send back an acknowledgement.
[P1](TX) or [P2] is