Table of Contents
Advertisement
3.1
Installing and configuring your modem/router on your
computer's network card (Ethernet)
3.1.1
In Windows
The Ethernet socket marked
connect your computers or wired Ethernet network elements. This port is a 10/100BASE-T port.
It supports bit rates of 10 Mbit/s and 100 Mbit/s in Half or Full Duplex mode on a category 5
double twisted pair.
This port is an RJ45 connector with self-detecting MDI or MDI-x type wiring.
To this port, you can connect, using a straight or cross-pinned Ethernet lead (not supplied with
the equipment):
• either directly to a computer equipped with an Ethernet 10/100BASE-T network card,
• or to an Ethernet local area network connected to a network concentrator (HUB or Switch).
The installation procedure described below was carried out in
Windows XP. Installation in other Windows operating systems (98,
ME and 2000) may present slight differences.
1
Insert the CD-ROM in your computer's
appropriate drive; the screen opposite
appears.
Carry out the operations described on
screen.
Click the
continue installation.
Note: If this screen does not appear: In the Start menu, select Run then enter:
"<CD-ROM drive letter> :\F@st1200.exe then click OK.
Sagem Communication document. Reproduction and disclosure prohibited
ETH
on your SAGEM F@st™ 1200/1240 is provided for you to
button to
SAGEM F@st™ 1200/1240 User Guide - 252569421-01
3 - Installing your modem/router
Page 3-3
Advertisement
Table of Contents
