Table of Contents
Advertisement
RFC1483 Routed
Field
Network Setting
WAN IP Address
WAN Subnet Mask
PPPoE
Field
Network Setting
Authentication
User Name
Password
Dialling
Idle timeout (min)
Sagem Communication document. Reproduction and disclosure prohibited
:
Check the appropriate box to enable address
Enable NAT
translation (NAT) (Recommended).
Enable DHCP :
Check
modem/router's "DHCP client" function.
This field is active only when the "DHCP client" function is deactivated
(Enable DHCP field check box not checked).
Enter a WAN IP address.
This field is active only when the "DHCP client" function is deactivated
(Enable DHCP field check box not checked).
Enter a WAN subnet mask.
:
Check the appropriate box to enable address
Enable NAT
translation (NAT) (Recommended).
Select one of the proposed authentication modes (CHAP or PAP).
Enter the user name (32 characters maximum) supplied by your
Internet Service Provider (ISP).
Enter the password (32 characters maximum) supplied by your Internet
Service Provider (ISP).
Select:
AUTO
: The PPPoE link will be set up only if there is traffic on the
ADSL line.
DIRECT
: The PPPoE link will always be set up even if there is no
traffic on the ADSL line.
Select DIRECT (Recommended).
Enter a delay (expressed in minutes) after which the PPPoE link will
disconnect in the absence of Internet traffic.
SAGEM F@st™ 1200/1240 User Guide - 252569421-01
5 - Configuration
Meaning
the
appropriate
box
Meaning
to
activate
the
Page 5-11
Advertisement
Table of Contents
