Installing And Configuring Your Router With The Network Card Of Your Computer (Ethernet) - Sagem 1201 Reference Manual

3 - Installing and configuring the router
3.1 Installing and configuring your Router with the network card
of your computer (Ethernet)
The Ethernet fixed connector marked ETH of your router is designed for connecting your
computers or wired Ethernet network equipment. It supports 10 Mbit/s and 100 Mbit/s
transmission rates in Half or Full Duplex mode on a category 5 double twisted pair cable.
This port is a RJ45 connector with wiring of the self-detecting MDI or MDI-x type.
With this port, you can connect using a straight or crossed Ethernet cord:
•
either directly to a computer equipped with a 10/100BASE-T Ethernet network,
•
or to an Ethernet local network connected to a network concentrator (HUB or Switch).
The installation procedure described below was undertaken in
Windows® XP. Installation in other Windows operating systems® (98,
ME and 2000) can be slightly different.
1 You have selected the Ethernet
interface; the screen opposite appears.
Make the electrical connection as
described on the screen.
Click button
the installation.
2 The screen opposite appears.
Make the connection of the ADSL line
as described on the screen.
Click button
the installation.
SAGEM F@st™ 1201/1241 Reference Manual - 288110393-01
Page 3-4 Sagem Communication document. Reproduction and disclosure prohibited
to continue
to continue