Page 1
ANGLOPACK Quick Setup Guide Sagem F@st 3102 modem Required configuration - A standard line: non-shared analog (excluding “Numeris” and switchboard) - A subscription to the ADSL service AngloPack from Teleconnect - A standard telephone (optional) - A computer with the following characteristics: •...
Installation 1/ Configure your PC network Then select: Point-to-Point Protocol over Ethernet (PPPoE) The Internet Protocol properties must be set to the following : • - obtain an IP address automatically - obtain a DNS address automatically To configure the network on your PC, please check your computer •...
Wiring Diagram Main Telephone Male RJ45 socket Ethernet Please ensure you have connected Cable the ADSL filter provided to your telephone socket. or Wi-Fi (no cable) if enabled on both the modem & your Male RJ11 cable computer During an electrical storm ADSL disconnect the box from the ETH1...
Wi-Fi configuration (optional) For your convenience, the Wi-Fi interface of your 3/ Follow the Wi-Fi instructions of your PC box is enabled by default. However, you may You will also need to configure the Wi-Fi device of your computer. • choose to enable/disable it.
Page 6
What to do if a problem arises? Event Test procedure or possible cause Please check that the power supply block is properly plugged in. Check that the power supply cable is properly connected to your router. The Power light is off Check that the electrical socket is in working order by plugging a different device into.