Safety And Homologation Statements; Lithium Batteries; Lightening Protection/Hazard Symbols - Avaya IP403 Installation Manual

Page 52 - Lithium Batteries

Safety and Homologation Statements

CE Mark
The "CE" mark affixed to this equipment means that the unit complies with the 1999/5/EC
(R&TTE), 89/336/EEC (EMC) and 72/23EEC (LVD) Directives
Declaration of Conformity
The Declaration of Conformity (DoC) for the IP400 Office products is contained with in the
CD accompanying the products.
The Avaya IP400 Office units are intended to be installed by 'Service Personnel' and
it is the responsibility of the Service Personnel to ensure that all subsidiary
interconnected equipment is wired correctly and also meet the safety requirements

Lithium Batteries

A lithium battery is fitted to the real time clock on the IP403, IP406 V2 and IP412 mother
boards.
The Lithium battery must only be replaced by Avaya personnel or authorized
representatives. There is a danger of explosion if the battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the manufacturer.

Lightening Protection/Hazard Symbols

Lightening protectors
The buildings lightening protectors must be verified as follow:
1. Check the lightening protectors, at the trunk cable entry point to the building housing
the Avaya IP Office, paying special attention to the lightening protection grounding.
Report any problems, in writing, to the telephone company.
2. Equipment that is designed to be connected using internal wiring is typically not
lightening protected. Hence, Avaya IP Office extension cabling must not leave the
building. For installations where telephones and/or other standard (tip/ring) devices
are installed in another building then lightening protection is required (see page 32).
Hazard Symbol
1. Never install telephone wiring during a lightening storm.
2. Never install telephone jacks in wet locations unless the jack is specifically designed
for wet locations.
3. Never Touch uninsulated telephone wires or terminals unless the telephone line has
been disconnected at the network interface.
4. Always use caution when working with telephone lines.
Page 52 - Safety and Homologation Statements
Lithium Batteries
This warning symbol is found on the base of IP403, IP406 V2 and IP412
units and on the base of the IP400 Digital Station 80W Lump in Line PSU
(see page 20). Refer to page 54 for information concerning which Trunk
Interface module variants are fitted in which country.
of IEC60950 or UL60950 where applicable.
Dispose of used batteries according to the manufacturer's instructions.
The shock hazard symbol is intended to alert personnel to electrical hazard
or equipment damage. The following precautions must also be observed
when installing telephone equipment:
Safety and Homologation Statements
WARNING
WARNING
IP Office (R2.1) Installation Manual
40DHB0002UKCL – Issue11c (19th November 2004)