Introduction; General; Scope Of Manual - Avaya IP403 Installation Manual

Introduction

Introduction

General

This manual covers the installation of your Avaya IP403/406 V2/412 Office equipped with
software release Level 2.1 only. It is intended for use by installers and maintainers who
have successfully completed the appropriate IP Office training courses.
Ensure that you have read and understood this manual before beginning installation.
For installation instructions for the Avaya IP Office - Small Office Edition, refer to the
separate Small Office Edition Installation Manual. For IP401 and the IP406 V1 platforms,
refer to previous issues of this manual (up to Issue 10).

Scope of Manual

This manual, for Avaya IP Office systems, covers the following subjects and should be
read in the sequence shown below:
– Avaya IP Office Platforms :
This section provides details of the various Avaya IP Office platforms available.
Illustrations of the front and rear of each unit show what ports/sockets/etc are provided.
Typical configuration examples are also provided in this section. A further section
details the country variants of modules/trunks/integral modules/etc.
– Preparing for and Installing a new system :
These sections provide all the information required and the actions to be performed to
physically install an IP Office, i.e. what tools are required, the environmental/power
requirements, wall mounting, rack mounting, etc. The software installation is covered in
the following section.
– Basic System Programming :
System programming is necessary for configuration and maintenance of the Avaya IP
Office. This manual only covers the installation of the IP Office suite of programs (see
page 41). For full details refer to the Installation Wizard Help files and/or to the
Manuals contained on the documentation CD (supplied with every unit).
– Terminal/Telephone Installation :
This manual details the information required to install telephones but does not detail
the usage and functionality of IP Office terminals/telephones. These details are to be
found in the appropriate User Guides.
The terminals/telephones that are supported by the IP Office are (these are also used
across a number of Avaya platforms) are:
Avaya 2000 Series
Avaya 2400 Series
Avaya 3600 Series
Avaya 4400 Series
Avaya 4600 Series
Avaya 6400 Series
*Caution: See page 63 for wiring details on a 4450DSS module.
For maximum cable run lengths for connection between IP Office units and terminals
refer to Terminal/Telephone Cable Lengths on page 74.
– Safety and Homologation Statements :
This provides all the necessary Safety, Homologation Statements and Regulatory
Instructions for Use required. This section also detail where further information,
including other Manuals and support telephone numbers, can be obtained.
– Technical Data :
This manual contains information on the Port Pinouts/Safety classifications, cables,
and basic technical specifications only (see page 74). Descriptions of the functionality,
features and performance of the IP Office are covered by the Product Description.
IP Office (R2.1) Installation Manual
40DHB0002UKCL – Issue11c (19th November 2004)
20AT, 20CC, 2010, 2030, 2050, 20DSS/BLF and 20DT
2420
3616, 3626
4406D, 4412D, 4424D and 4450DSS*
4602, 4602SW, 4620, 4606, 4612 and 4624
6408D+, 6416D+M, 6424D+M and XM24(DSS)
General - Page 5
Introduction - Page 5
General