Table of Contents
Advertisement
REPAIR PROCEDURE
Proceed as follows:
stop the vehicle in a position that
is not dangerous for oncoming traffic
where you can change the wheel;
stop the engine, apply the parking
brake and engage 1 st or reverse gear;
before getting out of the vehicle,
put on the reflective safety jacket (if
required by the regulations in force). In
any case, follow the road safety laws
in force in the country where you are
driving;
insert the sealant cartridge (A)
into the corresponding compressor
compartment (F) and press it down
hard until you feel the locking
mechanism click. Detach the speed
limit sticker (D) and apply it in a clearly
visible position;
insert the cartridge (A) containing
the sealant into the corresponding
compressor compartment (F) and
press it down hard until you feel the
locking mechanism click. Remove the
speed limit sticker (D) and apply it in a
clearly visible position;
wear the gloves;
remove the cap from the tyre valve
and connect and screw the transparent
tube of the sealing fluid (E) onto the
valve. Make sure that the ON/OFF
button is in the OFF position.
311
insert the electrical connector (H)
fig. 311 in the 12 V power socket of the
vehicle and start the engine;
operate the compressor by pressing
the ON/OFF button (ON position)
fig. 310. When the pressure gauge
reads the pressure (B) shown in the
"Wheels" paragraph in the "Technical
data" chapter, stop the compressor by
pressing the ON-OFF button again;
disconnect the cartridge (A) from the
compressor, by pressing the release
button (G) and lifting the cartridge
upwards.
If the pressure gauge (B) fig. 310
indicates a pressure lower than
3 bar 15 minutes after starting
the compressor, switch off the
compressor, disconnect the sealing
fluid tube (E) from the tyre valve and
remove the cartridge (A) from the
compressor.
Move the vehicle approximately 10
metres to distribute the sealant.
Stop the vehicle safely, operate the
parking brake and restore pressure
using the black inflation pipe (C)
fig. 310 to reach the required pressure.
If the pressure is still lower than 3
bar 15 minutes after switching on,
do not resume driving but contact a
Dealership. After driving for about 8 km
F1A0742
/ 5 miles, stop the vehicle in a safe
and suitable area, and engage the
parking brake. Take the compressor
and restore pressure using the black
inflation tube (C).
If the pressure reading is higher than 3
bar, restore the pressure and drive with
great care to the nearest Dealership.
PROCEDURE FOR
RESTORING THE
PRESSURE
Proceed as follows:
stop the vehicle safely as described
above, and engage the parking brake;
extract the black inflation tube and
screw it firmly onto the tyre valve. Then
follow the instructions below.
CARTRIDGE
REPLACEMENT
Proceed as follows:
only use original cartridges, which
can be purchased from the Dealership.
251
Advertisement
Table of Contents
