Table of Contents
Advertisement
241
WARNING In case of narrow bends,
the performance of the system could
be limited. In this case, it is advisable to
deactivate the system.
Using the system on gradient
When driving on roads with variable
gradient, the system may not detect
the presence of a vehicle on the
lane. The system performance be
limited according to speed, load of the
vehicle, traffic conditions and gradient
steepness.
Lane change
The system may not detect the
presence of a vehicle until it is fully in
your lane fig. 242.
In this case, sufficient distance from the
vehicle which is changing lane may not
be guaranteed: it is advisable to pay
the utmost attention at all times and
be always ready to press the brakes if
needed.
F1A0997
242
Small vehicles
Some narrow vehicles (e.g. bicycles
and motorcycles fig. 243) travelling
near the outer edges of the lane or
which enter the lane from kerbside are
not detected until they are fully in the
lane.
Sufficient distance from the vehicles
ahead may not be guaranteed in these
cases.
243
Stationary objects and vehicles
The system cannot detect the
presence of stationary objects and
vehicles if you are travelling at a speed
exceeding 60 km/h (37 mph). For
example, the system may not operate
if the vehicle ahead leaves the lane
and a car stopped on the lane ahead
of if. Pay the utmost attention at all
times and be always ready to press the
brakes if needed.
Objects and vehicles moving in
F1A0996
opposite or crosswise direction
The system cannot detect the
presence of objects or cars travelling in
opposite or crosswise direction fig. 244
and consequently will not be operated.
244
F1A0995
F1A0731
203
Advertisement
Table of Contents
