Table of Contents
Advertisement
141
Manual adjustment
16)
With the vehicle stationary and the
engine on or off, the desired height
level can be set.
Manual adjustment is only available
for a limited number of times with the
engine switched off.
Pressing button (A), for less than 1
second, selects the next level up.
Keeping button (A) pressed for more
than 1 second directly selects the
maximum level: "position +3".
Pressing button (B), for less than 1
second, selects the next level down.
Keeping button (B) pressed for more
than 1 second directly selects the
minimum level: "position -3".
While adjusting, the LED located on the
button ((A) or (B) ) corresponding to the
direction of travel, flashes.
Adjustment not available
If, after selecting a button, the LED
remains lit up (for about 5 seconds)
rather than flashing, this means that the
adjustment is temporarily unavailable.
Possible causes may be as follows:
insufficient air reserve: the function is
restored by starting the engine;
the system has reached a threshold
working temperature: wait a few
F1A0634
minutes to let it cool down before
operating the buttons again.
The level selected with the vehicle
stationary is maintained up to a speed
of about 20 km/h; when this speed is
exceeded, the system will automatically
restore the normal level: "position 0".
WARNING
16) Before manually adjusting with
doors open, make sure there is enough
space around the vehicle for this kind of
operation.
ROOF RACK/SKI
RACK
To fit the roof/ski rack, with provision
for versions H1 and H2, use the pins
(A) on the edges of the roof fig. 142.
142
Long wheelbase vehicles are equipped
with 8 pins; short or medium
wheelbase vehicles are equipped
with 6 pins; vehicles with extra-long
wheelbases are equipped with 10 pins.
51) 52)
17) 18)
WARNING Follow the instructions
contained in the assembly kit carefully.
Assembly must be performed by
qualified personnel.
F1A0130
77
Advertisement
Table of Contents
