Recalling The Speed - Fiat Ducato 2021 Owner's Handbook Manual

Table of Contents

Advertisement

The device cannot be turned on in
either reverse or in neutral.
WARNING It is dangerous to leave the
device on when it is not used. There
is a risk of inadvertently activating it
and losing control of the vehicle due to
unexpected excessive speed.
SETTING THE DESIRED
SPEED
Proceed as follows:
operate the device (see the previous
instructions);
when the vehicle has reached the
desired speed, press button SET +
(or SET –) and release it to activate
the device. When the accelerator
is released, the vehicle will keep the
selected speed automatically.
If needed (when overtaking for
instance), you can accelerate simply
by pressing the accelerator; when you
release the pedal, the vehicle goes
back to the speed stored previously.
When travelling downhill with the device
active, the vehicle speed may slightly
exceed the stored one.
WARNING Before pressing the SET +
(or SET –) buttons, the vehicle must be
travelling at a constant speed on a flat
surface.
176
INCREASING /
DECREASING SPEED
Increasing speed
Once the electronic Cruise Control
has been activated, the speed can be
increased by pressing button SET +.
Keeping the button pressed, the set
speed will increase until the button is
released, then the new speed will be
stored.
Each time button SET + is pressed the
set speed will be fine tuned.
Decreasing speed
With the device activated, the speed
can be decreased by pressing button
SET –.
Keeping the button pressed, the set
speed will decrease until the button is
released, then the new speed will be
stored.
Each time button SET – is pressed the
set speed will be fine tuned.
WARNING Pressing the button SET
+ (or SET –) the speed is adjusted
depending on the selected unit of
measurement ("metric" or "imperial")
set through the Menu of the instrument
panel display or, depending on the
versions, in the menu of Uconnect™
(see "Settings" in the "Vehicle mode"
paragraph in the "Multimedia" section).
WARNING On steeply sloping roads,
the system may not be able to maintain
the set speed, which may increase the
speed of the vehicle. It is, therefore,
preferable to switch the device off
under these conditions. The device
keeps the speed stored even uphill and
downhill. A slight variation in the speed
on slight rises is completely normal.

RECALLING THE SPEED

With transmission operating in D
(Drive), press and release the RES
button to recall the previously set
speed.
DEACTIVATING THE
DEVICE
Pressing the CANC button or
pressing the brake pedal as the
vehicle is slowing down deactivates
the electronic Cruise Control without
deleting the stored speed.
The Cruise Control can also be
deactivated if the electric parking
brake (EPB) is activated or if the
braking system intervenes (e.g. the
ESC system) or in other particular
conditions.
The stored speed is deleted in the
following cases:
pressing button
or
or
switching off the engine;

Advertisement

Table of Contents
loading

Table of Contents