Parksense System; Speed Block; Increasing/Decreasing And Storing Engine Idle Preset - Fiat Ducato 2021 Owner's Handbook Manual

Table of Contents

Advertisement

INCREASING/DECREASING
AND STORING ENGINE
IDLE PRESET
It is possible to access the menu to
set the desired engine idle speed ("Idle
speed selection") using the control
buttons located on the left side of the
steering wheel.
This menu item allows you to set the
desired value for minimum engine
speed using the control buttons:
minimum: 900 rpm
maximum: 2200 rpm
increase/decrease: 50 rpm
The system stores the current engine
idling speed as a new preset value.

SPEED BLOCK

(for versions/markets, where provided)
The vehicle is equipped with a speed
limitation function that can be set on
the user's request to one of four default
values: 90, 100, 110, 130 km/h.
To activate/deactivate this function,
contact a Fiat Dealership.
Following the operation, a sticker will
be applied to the windscreen showing
the top speed setting.
IMPORTANT The speedometer could
indicate a higher maximum speed than
the effective one, set by the Dealership,
in accordance with the regulations in
force.
178
PARKSENSE
SYSTEM
(where provided)
148)
49) 50) 51)
VERSIONS WITH 4
SENSORS
The parking sensors, located in the rear
bumper fig. 215, are used to detect
the presence of any obstacles near the
rear part of the vehicle. The sensors
warn the driver about the presence
of obstacles with acoustic signal
and, where provided, also with visual
indications on the instrument panel
display.
215
System activation/deactivation
Activation
The system is automatically activated
when reverse is engaged.
Deactivation
The system is automatically deactivated
whenever a gear other than reverse is
engaged.
Acoustic warning
When reverse is engaged and there is
an obstacle behind the car, an acoustic
warning with variable frequency is
activated:
increases as the distance between
the vehicle and the obstacle decreases;
becomes continuous when the
distance between the vehicle and the
obstacle is less than 30 cm and stops if
the distance increases;
remains constant if the distance
between the vehicle and the obstacle
remains unchanged. If this situation
concerns the exterior sensors, the
signal will stop after approximately
3 seconds to avoid, for example,
indications in the event of manoeuvres
along a wall.
If several obstacles are detected by
the sensors, only the nearest one is
considered.
Warning on display
F1A0134
The warnings regarding the
ParkSense ® system are shown on
the instrument panel display only if the
"Acoustic warning and display" item
in the "Settings" menu is selected

Advertisement

Table of Contents
loading

Table of Contents