Table of Contents
Advertisement
pressing the
button. The operating
mode can be changed according to
your wishes.
Quick start of the water heater
The quick start button is programmed
for heating.
Press the quick start button
The heating is started. The "Heating"
menu item and the preset remaining
time appear in the display. The quick
start button lights up green.
Temperature adjustment during
heating operation
The heater is running.
Turn the control button, select the
required temperature.
Press the control button within 5
seconds to confirm your selection.
Adjusting the heating level during
operation
Heater with selectable heating levels.
The heater is running.
Press the control button to toggle
between temperature selection and
heating level selection.
Press the arrow button to select the
required heating level.
Press the control button within 5
seconds to confirm your selection.
Remaining time adjustment
A longer operating time must be set is
a longer residual time is preferred. No
further changes can be made after a
minimum operating time of 10 minutes.
An extension is only possible after
switching off and on again.
Remaining time of the water heater
The heater is running.
Turn the control button to select the
.
operating time "Minutes".
Then press the control button to
confirm the selection. The heating is
started. The "Heating" menu item and
the preset remaining time appear in the
display. The quick start button lights up
green.
TURNING OFF
The heater is running.
Press the quick start button. The
lighting of the quick start button
changes from green (in heating mode)
to white.
TIMER PROGRAMMING (PRESET
TIME)
This function is only available with
the MultiControl control panel. Pre-
selection times can be scheduled up to
7 days in advance. The heater switches
on automatically at the programmed
time. You can store up to 3 preset
times per day and up to 21 preset
times in total. The number of active
timers available may vary according
to the MultiControl variant used and
the type of application (e.g. car, truck,
boat, etc.). A maximum number of 21
active timers can be available.
Timer: preset time setting
Current time and day of the week are
set.
The heater is off.
The "Timer" menu item has been
selected in the main menu.
Press the control button. "Update
programmed time" appears in the
display (if no timer has been saved yet).
Press the control button to add a
new timer.
Turn the control button to select the
"Day of the week".
Then press the control button to
confirm the selection.
Turn the control button to select the
"Hour" power on time.
Then press the control button to
confirm the selection.
The "Minute" start time is set as the
"Hour" start time.
Turn the control button to select the
"Hour" stop time.
Then press the control button to
confirm the selection.
The "Minute" stop time is set as the
"Hour" stop time.
Timer: Heating mode setting
All heaters:
Then press the control button to
confirm the selection. The timer is
61
Advertisement
Table of Contents
