Refilling With Containers; Refilling With Nozzles; Operations After Refilling - Fiat Ducato 2021 Owner's Handbook Manual

250
The sealing may cause a slight
pressure increase in the tank. A little
breathing off, while slackening the cap
is absolutely normal.
In case of loss or damage to the
fuel tank cap, make sure that the
replacement cap is for the appropriate
vehicle.
Tighten the cap of the fuel tank filler
until you hear a "click". This sound
shows that the cap of the fuel tank filler
is properly tightened.
For versions / markets where provided,
turn the key clockwise until it stops. It is
not necessary to apply an additional
load on the key to complete the
tightening of the cap. Only in the case
where the cap has been tightened
properly, it will be possible to remove
the ignition key from the cap.
After each refuelling, make sure the fuel
filler cap is securely tightened.
210
WARNING When the gun distributor
fuel "snaps" or interrupts the supply,
the tank is nearly full and you can run
two additional top-ups after shooting
automatic.
175) 176) 177)
TOPPING UP AdBlue®
DIESEL EMISSIONS
ADDITIVE (UREA)
F1A0765
Preliminary Conditions
AdBlue ® (UREA) freezes at
temperatures lower than -11°C. If the
vehicle stands for a long time at this
temperature refilling could be difficult.
For this reason, it is advised to park
the vehicle in a garage and/or heated
environment and wait for the AdBlue ®
(UREA) to return to liquid state before
topping up.
Proceed as follows:
park the vehicle on ground level;
stop the engine by turning the
ignition device to MAR;
open the fuel flap A (A)fig. 250 and
then unscrew and remove the cap (C)
(blue colour) from the AdBlue ® (UREA)
filler.

Refilling with nozzles

You can fill up at any AdBlue ® (UREA)
distributor.
Proceed as follows:
insert the AdBlue ® (UREA) nozzle
in the filler, start refilling and stop
refilling at the first shut-off (the shut-off
indicates that the AdBlue ® (UREA) tank
is full).
Do not proceed with the refilling and
remove the nozzle to prevent spillage.

Refilling with containers

Proceed as follows:
check the expiration date;
read the advice for use on the label
before pouring the content of the bottle
into the AdBlue ® (UREA) tank;
if systems which cannot be screwed
in (e.g. tanks) are used for refilling,
after the indication appears on the
instrument panel display (refer to
the "Warning lights and messages"
paragraph), fill the AdBlue ® (UREA)
tank with no more than 10 litres;
if containers which can be screwed
to the filler are used, the reservoir is full
when the AdBlue ® (UREA) level in the
container stops pouring out. Do not
proceed further.

Operations after refilling

Proceed as follows:
fit the cap (C)fig. 250 back on the
AdBlue ® (UREA) filler by turning it
clockwise and screwing it completely;
set the starter switch to MAR (it is
not necessary to start the engine);