Table of Contents
Advertisement
Air distribution selection
Pressing the button (G) fig. 101
on the dashboard or the graphic
buttons located on the display of the
Uconnect™ system, you can manually
set one of the following air distribution
possibilities:
Airflow at central and side
dashboard vents to ventilate the chest
during the hot season.
Airflow to the front and rear footwell
vents. This air distribution setting heats
the passenger compartment most
quickly, giving a prompt sensation of
warmth.
Air flow towards windscreen.
Maximum windscreen defrosting.
You can select the combination of
several modes by pressing the buttons
in sequence.
In AUTO mode, the climate control
system automatically manages the
air distribution. The air distribution,
when manually set, is displayed on the
Uconnect™ system A/C screen.
Fan speed adjustment
Press button (C) to increase/decrease
the fan speed:
press downwards: decrease speed;
press upwards: increase speed.
The speed is displayed on the A/C
screen of the Uconnect™ system. A
specific fan level can be selected by
56
pressing the arrows of the dedicated
button:
maximum fan speed: all bars are lit
up;
minimum fan speed: one bar is lit
up.
WARNING To restore automatic
control of the fan speed after a manual
adjustment, press the AUTO button.
AUTO button
When the AUTO button (L) is
pressed the climate control system
is automatically adjusted in the
corresponding zones:
quantity and distribution of the
air introduced into the passenger
compartment;
climate control compressor;
air recirculation;
cancelling any previous manual
settings.
If a manual intervention is made on
the air distribution or on the fan speed
the climate control system is no longer
controlling all functions automatically.
To restore automatic system control
after one or more manual adjustments,
press the AUTO button.
Air recirculation
The air recirculation can be switched
on/off by pressing the button (E)
fig. 101.
WARNING The engagement of the
recirculation system makes it possible
to reach the required heating/cooling
conditions faster. It is, however,
inadvisable to use it on rainy/cold days,
or with low external temperatures, as
it would considerably increase the
possibility of the windows misting up
inside rapidly (especially if the climate
control system is off).
When the outside temperature is low,
recirculation could be switched off (air
drawn from the outside) to prevent the
windows misting up.
In automatic operation inside air
recirculation will be controlled
automatically by the system according
to outside environmental conditions.
Climate control
compressor
Press button (F) fig. 101 to
activate/deactivate the compressor.
Switching off the compressor remains
stored even after the ignition device has
been turned to the STOP position.
To restore automatic control of
compressor engagement, press again
Advertisement
Table of Contents
