Table of Contents
Advertisement
not being started (with accessories still
plugged in), the vehicle must be driven
a sufficient length of time to allow the
alternator to recharge the battery.
15) Power sockets are designed for
accessory plugs only. Do not insert any
other object in the power sockets as this
will damage the socket or blow the fuse.
Improper use of the power socket can
cause damage not covered by your limited
warranty of the vehicle.
TACHOGRAPH
(for versions/markets, where provided)
For tachograph operation and use,
consult the owner handbook supplied
by the device manufacturer. The
tachograph must be installed on the
vehicle when the vehicle weight (with or
without trailer) exceeds 3.5 tons.
WARNING Anyone making changes
to the monitoring device or signal
transmission system that affects
recording by the monitoring instrument,
particularly if this is done for purposes
of fraud, may be in breach of criminal
or administrative state regulations.
WARNING If a tachograph is fitted, if
the vehicle is parked for more than 5
days, it is advisable to disconnect the
negative battery terminal to maintain its
charge.
76
WARNINGS
Do not use abrasive detergents or
solvents to clean the device.
To clean the device externally, use a
damp cloth or special products for the
care of synthetic materials.
The tachograph is installed and sealed
by authorised personnel: do not try
and access the device or the supply
and recording leads in any way. It is
the responsibility of the owner of the
vehicle on which the tachograph is
installed to check the device regularly.
The check must be carried out at least
every two years and a test must be
carried out to ensure it is operating
properly. Ensure that the data label
is renewed after every check that the
label contains the specified data.
SELF-LEVELLING
AIR SUSPENSION
GENERAL INFORMATION
The system only acts on the rear
wheels.
The system maintains the rear ride
setting for the vehicle constant in any
loading condition, while ensuring a
greater driving comfort.
In addition, the system allows the
height of the vehicle to be adjusted with
the vehicle stationary, by selecting from
7 different positions to facilitate access
to the rear compartment.
HEIGHT ADJUSTMENT
There are 7 pre-defined levels for the
free height from the ground: from "ride
-3" to "ride 0" till "ride +3".
The ride information is displayed on the
instrument panel.
Automatic adjustment
Whilst driving the system automatically
restores the vehicle to "position 0" and
keeps it constant.
While adjusting, the LED located
on the button ((A) or (B) fig. 141)
corresponding to the direction of travel,
flashes.
Advertisement
Table of Contents
