Speed Limiter - Fiat TIPO 5DOOR 2023 Owner's Handbook Manual

SPEED LIMITER

(where provided)
DESCRIPTION
This device allows the speed of the car
to be limited to values which can be set
by the driver.
The maximum speed can be set both
with car stationary and in motion. The
minimum speed that can be set is
30 km/h.
When the device is active, the car
speed depends on the pressure
at the accelerator pedal, until the
programmed speed limit is reached
(see "Speed limit programming"
paragraph).
ACTIVATING THE DEVICE
To activate the device press button (1)
fig. 160 on the steering wheel.
160
When the device is enabled, it is
indicated by the symbol being
shown on the display and the last
speed set.
If the electronic Cruise Control has
been activated previously, button (1)
fig. 160 must be pressed twice.
The first press switches off the function
activated previously; the second press
activates the Speed Limiter.
SPEED LIMIT
PROGRAMMING
The speed limit can be programmed
without necessarily activating the
device.
To store a speed value higher than
the displayed one, briefly press the
SET + button. Each time the button
is pressed, the speed increases by
about 1 km/h while keeping the button
pressed, the speed increases by
5 km/h intervals.
To store a lower speed value than the
displayed one, press the SET – button.
Each time the button is pressed, the
speed decreases by about 1 km/h
while keeping the button pressed, the
speed decreases by 5 km/h intervals.
DEVICE
ACTIVATION/
DEACTIVATION
Device Activation : press the SET + or
SET – buttons, at a speed between 30
P2000319
and 130 km/h, to set the current car
speed as the speed limit. Or, press the
RES (Resume) button to set the speed
limit to the value shown on the display.
The device activation is indicated by
the symbol on the display.
Device deactivation : press the CANC
button. The device deactivation is
indicated by the grey symbol on the
display.
EXCEEDING THE
PROGRAMMED SPEED
By fully depressing the accelerator
pedal, the programmed speed can be
exceeded even with the device active
(e.g. in the event of overtaking).
The device is disabled until the speed
drops below the set limit, after which it
reactivates automatically.
FLASHING OF
PROGRAMMED SPEED
The programmed speed flashes in the
following cases:
when the accelerator pedal has
been fully depressed and the car has
exceeded the programmed speed;
activating the system after setting a
limit below the effective speed of the
car;
when the device cannot reduce
the speed of the car due to the
gradient of the road, in this case also
accompanied by an acoustic warning;
151