Altitude Ap's Led States - Extreme Networks Summit WM100 Getting Started Manual

7.7 Altitude AP's LED states

Left LED Status Center LED Status
Off Off
Off Green
Off Off
Off Red
Green Off
Green/Off Off/Green
Green/Off/Off Off/Green/Off
Off Orange
(Green + Red)
Off Red/Orange
Off Green/Orange
Off Off/Orange
Off Off/Red
Off Off/Green
Table 5 Altitude AP LED status
120385-00 Rev 01, March 2007
Summit WM, Getting Started Guide
When the Altitude AP is powered on and boots, you can follow its progress
through the registration process by observing the LED sequence described
below.
The Status LED (center) also indicates power — unlit when unit is off, and green
(solid) when the Altitude AP has completed discovery and is operational.
Figure 12 Altitude AP LEDs
Right LED Altitude AP Status
Status
Off Powered-off
Off Beginning of Power-on-Self-Test (POST) (0.5 seconds)
Off Power-on-Self-Test (POST
Off Failure during POST
Green Random delay – State displayed only after a vulnerable reset
Green/Off Vulnerable time interval – The Altitude AP resets to factory
default if powered-off for three consecutive times during this
state. No vulnerable period when Altitude AP is resetting to
factory defaults.
Off/Off/Green Resetting to factory defaults announcement – replaces
vulnerable period. This pattern is repeated twice to notify the
operator when the factory configuration is restored.
Off Attempting to obtain an IP address via DHCP.
Off No DHCP reply has been received.
Off Failed discovery (SLP)
Off Summit WM Switch has been discovered. Registering the
Altitude AP.
Off Registration of the Altitude AP has failed.
Off Standby, registered with a Summit WM Switch, waiting for
configuration.
HWC_GSG_APConfiguration.fm
Altitude AP's configuration
Altitude AP's LED states
93