Table of Contents
Advertisement
HWC_GSG_APConfiguration.fm
Altitude AP's configuration
Configuring the Altitude APs for the first time
84
7.2.1 Manually approving pending Altitude APs
If the Summit WM Switch does not recognize the Altitude AP, the Altitude AP's
registration record is created in pending state. You must manually approve a
pending Altitude AP. As long as the Altitude AP is in pending state, it receives
minimum configuration that only allows it to maintain an active link with the
Summit WM Switch for future state change.
To manually approve pending Altitude APs:
1. From the main menu, click Altitude AP Configuration. The Altitude AP
screen is displayed
2. In the left pane, click Access Approval. The Access Approval screen is
displayed.
3. In the Select Altitude APs section, click Pending. The pending Altitude APs
are selected.
4. In the Perform action on selected Altitude APs, click Approved. The state
of the selected Altitude APs is changed from "Pending" to "Approved".
120385-00 Rev 01, March 2007
Summit WM, Getting Started Guide
Advertisement
Table of Contents
