Removing An Interface Card - Epson EPL-6100 Reference Manual

6. Slide the interface card into the grooves of the interface slot,
as shown below. Push the card in firmly to lock it into place.
Then secure the card with the two retaining screws.
7. Plug the printer's power cord back into the electrical outlet.
8. Turn on the printer.
To verify that the card is correctly installed, print a status sheet.
See "Printing a Status Sheet" on page 104 to print a status sheet.
If the installed interface is not shown on the status sheet, turn off
the printer, unplug it, disconnect all interface cables, and review
the steps above to make sure you installed the interface card
correctly. If the installed interface still does not show up in the
status sheet, contact your dealer or a qualified service
representative for assistance.

Removing an interface card

Follow the instructions below to remove the optional interface
card:
1. Turn off the printer.
2. Unplug the printer's power cord from the electrical outlet.
3. Face the rear of the printer.
Installing and Removing Options
6
6
6
6
6
6
6
6
6
6
6
6
31