Epson EPL-6100 Reference Manual page 169

USB I/F Buffer Size
Allows you to specify the amount of memory to be used for
receiving and printing data through the USB interface. If set to
Maximum, more memory is allocated for receiving data. If set to
Minimum, more memory is allocated for printing data. The factory
default setting is Normal.
AUX I/F Buffer Size
Allows you to specify the amount of memory to be used for
receiving and printing data through the optional interface card.
If set to Maximum, more memory is allocated for receiving data.
If set to Minimum, more memory is allocated for printing data. The
factory default setting is Normal.
Toner Out Error
Allows you to set whether the printer should continue or stop
printing when the printer encounters a Toner Out error. If set to
Continue (default), the printer continues printing regardless of
the error. This setting is recommended if you are physically
distant from the printer. If set to Stop, the printer stops printing
when it encounters the Toner Out error.
Auto Continue
Permits the printer to automatically recover from a Print Overrun,
Insufficient Memory for Current Task, or Change Paper error. The
printer continues printing within a few seconds after one of these
problems occurs.
When Auto Continue is off, you must press the N Start/Stop
button to resume printing. In most cases, leave Auto Continue
Disable (default) so you can tell when an error occurs and make
the necessary corrections. You might want to set Auto Continue
to Enable when printing long jobs or when you are away from the
printer for long periods.
Using the Remote Control Panel Utility
7
7
7
7
7
7
7
7
7
7
7
7
67