Initializing Selectype To Factory Default Settings - Epson ActionLaser Plus User Manual

Using SelecType

Initializing SelecType to factory default settings

To initialize SelecType options, returning them to
settings, follow the steps below. (Factory settings are marked with
an asterisk (*) in the SelecType Options section.)
1. Press the
ON LINE
2. Press the SelecType button to enter SelecType. This message
appears:
PAPER SIZE = LTR*
3. Hold down
the message
4. Your printer is set off
OFF LINE LTR
5. Hold down the
until the
message RESET
6. Your printer is set on line. This message appears in the display:
ON LINE LTR
7. If initializing SelecType changes your DATA
or interface submenu settings, you should also turn off the
LOAD,
printer to save these settings. (Remember to wait for at least five
seconds before turning the printer back on.)
3-18 Using the Printer
button to set the printer off line.
the CONTINUE/RESET
appears in the display.
INITIALIZE
This message appears in
line.
CONTINUE/RESET
appears in the display.
the
button for three seconds until
button for three more seconds
BUFF E R, OVER
factory
display:
the