Fx Problems And Solutions - Epson ActionLaser Plus User Manual

FX Problems and Solutions

This section discusses problems you may encounter while using
FX emulation and their likely solutions.
If these suggestions do not solve the problem, call the Epson
Consumer Information Center at 1-800-922-8911 for a referral to
an Epson Customer Care Center.
Problem
The printout is
spaced incorrectly.
All the text is printed
on the same line.
There is
an extra
line between each line of
text.
The position of the
printout is not what
you expected.
The printed page length
differs the actual
from
length of the paper.
Solution
A line feed command is not being sent
at the end of each line of text. Set the
AUTO LF function in SelecType to
CR + LF.
An extra line feed signal is probably
blank
being sent. Set the
in SelecType to CR.
Your SelecType
or application settings may not be
correct. Check your SelecType
TOP OF FORM
page length and top margin settings
for your application program to
ensure that they are set correctly for
the desired page length. Make sure
your software is sending a Form Feed
(FF) command at the end of each page.
function
AUTO LF
TOP OF FORM setting
setting. Also check the
Troubleshooting
7-25