Initializing Selectype To Factory Default Settings - Epson Action Laser Action Laser User Manual

Using SelecType

Initializing SelecType to factory default settings

To initialize SelecType options, returning them to
settings, follow the steps below. (Factory settings are marked with
an asterisk (*) in the SelecType Options section.)
1. Press
the ON LINE
2. Press SelecType button to enter SelecType. This
the
appears:
PAPER SIZE = LTR*
3. Hold down
the message
4. Your printer is set off
OFF LINE LTR
5. Hold down the
until the
message RESET
6. Your printer is set on line. This message appears in the display:
ON LINE LTR
7. If initializing SelecType
or interface submenu settings, you should also turn off the
LOAD,
printer to save these settings. (Remember to wait for at least five
seconds before turning the printer back on.)
Using the Printer
3-18
button to set
the CONTINUE/RESET
appears in the display.
INITIALIZE
This message appears in
line.
CONTINUE/RESET
appears in the display.
changes
printer off line.
the
button for three seconds until
button for three more seconds
your
DATA BUFFER, OVER
factory
the
message
display:
the