Connecting To The Network; Installing Module Into Matrix N3, N1, Or N5 Chassis (Matrix N3 Shown) - Enterasys Matrix 7GR4202-30 Hardware Installation Manual

A DFE module can be installed in any available chassis slot: 1 through 3 in the Matrix N3 chassis,
the single slot of the N1 chassis, or 1 through 5 in the Matrix N5 chassis. All chassis have
horizontal slots for DFE modules. To install a DFE module into the Matrix N3, N1, or N5 chassis,
refer to Figure
Matrix E7 or N7 Chassis" on page 3‐10.
Figure 3-7
1 Card guides
2 Slot 1 (Top slot is slot 3.)
3 Module card
4 Metal back panel

Connecting to the Network

This section provides the procedures for connecting unshielded twisted pair (UTP) segments from
the network or other devices to the 7GR4202‐30 ("Connecting UTP Cables to the 7GR4202‐30" on
page 3‐14). For connections to Mini‐GBIC ports on the 7GR4270‐12 or the optional NEM, refer to
"Connecting Fiber‐Optic Cables to Mini‐GBICs" on page 3‐17.
3‐7 and use the installation procedure described in "Installing Module into
Caution: When setting the locking levers to the closed position, do not try to force the locking
levers to the point that they touch the face of the front panel. Forcing the locking levers to this
point could damage the module and chassis.
Precaución: Al mover las palancas a la posición de cerrado, tenga cuidado de no llevarlas a un
punto en donde estén en contacto con el panel frontal. Si lo hace, podría dañar el módulo o el
chasis.

Installing Module into Matrix N3, N1, or N5 Chassis (Matrix N3 shown)

Note: If the DFE module is being installed in a network using Link Aggregation, there are rules
concerning the network cable and port configurations that must be followed for Link Aggregation to
operate properly. Before connecting the cables, refer to the Enterasys Matrix DFE-Diamond/
Platinum Series Configuration Guide for the configuration information. For details on how to obtain
manuals, refer to the "Related
5 Upper locking tab (shown in closed position)
6 Lower locking tab (shown in closed position)
7 FTM2 backplane connectors
Documents" in About This Guide
Matrix DFE-Diamond Series Installation Guide 3-13

Connecting to the Network

.