Installing The Switch On A Wall (Shown With One D2-Pwr Supply) - Enterasys D2G124-12 Hardware Installation Manual

Figure 2-11

Installing the Switch On a Wall (shown with one D2-PWR supply)

1 Wall mounting screw holes (four)
2 Switch mounting screw holes (three)
3 AC power receptacle
4 Fan tab
5 Serial number access window
6
DC power cord
1. Ensure that you have appropriate screws for securing the assembled wall mount kit to your
wall location. These four screws are required and are not provided in the wall mount kit.
2. Mount the switch on the front side of the wall mount kit in the direction shown, aligning the
three screw holes on the bottom of the unit with the three holes in the wall mount tray.
Note: Ensure that the D2 switch is secured to the wall mount tray in the position shown, with the
back panel of the switch facing downward. The fan tab on the wall mount tray must face downward
when the kit is installed on the wall.
3. Using the screws provided, fasten the switch to the wall mounting tray.
4. Install a power supply by sliding it under the flange located on the bottom side of the wall
mounting tray.
7 Power supply (D2-PWR shown)
8 Power supply mounting flange
9 Power supply mounting bracket
10 Power supply hook & loop strap
11 AC power cord
Enterasys D-Series Hardware Installation Guide 2-13
Mounting the Switch