Mini-Gbic With Mt-Rj Connector (C1H124-48 Shown) - Enterasys C1H124-24 Installation Manual

To prepare and install a Mini-GBIC, proceed as follows:
Preparation
Before installing the Mini-GBIC, proceed as follows:
1. Attach the antistatic wrist strap (refer to the instructions in the antistatic wrist strap package)
before removing the Mini-GBIC from the antistatic packaging.
2. Remove the Mini-GBIC from the packaging.
3. If there is a protective dust cover (see
at this time.
Installation
To install a Mini-GBIC, refer to
1. Hold the Mini-GBIC
port slot .
2. Carefully align the Mini-GBIC
3. Push the Mini-GBIC
Figure 3-1 Mini-GBIC with MT-RJ Connector (C1H124-48 shown)
Mini-GBIC (MGBIC-MT01)
,
Mini-GBIC top side
7-Pin edge connector (insertion side)
Figure
Figure 3-1 or Figure
with its top side
with the port slot
into the port slot
Á
À
Ä
Å
3-1, ) on the Mini-GBIC port, do not remove it
3-2, and proceed as follows:
facing up and its 7-pin edge connector
.
until the Mini-GBIC "clicks" and locks into place.
Â
Port slot
,
Mini-GBIC protective dust cover
Release tab
Installing Optional Mini-GBICs
facing the
Ã
Hardware Installation 3-3