Resetting the D2-HIPWR-POE
The D2‐HIPWR‐POE will shut down in the event of an overload or short circuit.
To reset the D2‐HIPWR‐POE:
•
Disconnect AC power to one of the power supplies. Wait 30 seconds (to allow the DC output
voltage to decay enough to reset the D2‐HIPWR‐POE) before re‐applying AC power.
•
Remove and replace one of the D2‐HIPWR‐POE's power input cables, no minimum time
required.
Resetting the D2-HIPWR-POE
Enterasys D-Series Hardware Installation Guide 3-3