Installing One Or More Power Supplies; Fastening Switch(Es) To The Rack Mounting Tray (Two D2G124-12Ps Shown) - Enterasys D2G124-12 Hardware Installation Manual

Mounting the Switch
Figure 2-5
1 Rear edge of switch
3. Using the screws provided (three for each switch), fasten each switch to the rack mounting
tray as shown in Figure

Installing One or More Power Supplies

The D2 rack mount kit provides mounting positions for up to four power supplies (up to two for
each mounted switch). Depending on whether you have one or two switches in the rack mount
kit, and whether you want one or two power supplies for each switch, the method you use to
secure each power supply may vary slightly.
Choose one of the following options for installing a power supply in the rack mount kit:
• "Edge of Tray Installation" (page 2‐6)
• "Middle of Tray Installation" (page 2‐8)
Edge of Tray Installation
Using one of the hook & loop straps provided, secure a power supply to one of the edge mounting
positions on the rack mount kit as follows:
1. Thread the strap through the mounting tray as shown in Figure
one side of the power supply in the following order:
a.
b. In through the mounting hole just below the first mounting hole
c.
d. Through the appropriate bridge anchor
e.
2-6 Installation

Fastening Switch(es) to the Rack Mounting Tray (two D2G124-12Ps shown)

2‐5.
Out through the first mounting hole closest to the top of the mounting tray
Under the power supply
Wrap the ends of the strap over the top of the power supply and fasten securely.
Note: The bridge anchors you use to secure each power supply will depend on the power supply's
location in the rack mounting tray. Refer to
use all four sets of bridge anchors in staggered fashion to secure four power supplies.
2 Fastening screws (three per switch)
2‐6 on page 2‐7 and around
Figure 2-8 on page 2-9 for an illustration showing how to