Table of Contents
Advertisement
11
PROCEDURE FOR WRITING PROGRAM TO CPU
MODULE
1)
Connect the personal computer, which is
installed with GX Developer, to the CPU
module.
Set the RUN/STOP/RESET switch to the
STOP position, and power ON the PLC
(the "ERR". LED turns on).
Set the CPU access password in GX
Developer and register it in the CPU
module.
Choose [Online]
[Format PLC memory]
on GX Deveoper, and format the program
memory.
Choose [Online]
[Write to PLC] on GX
Deveoper, select "Program memory",
and write the parameters, created
program to the program memory.
Switch the PLC power OFF&drarroON or
end the CPU module reset.
Set the RUN/STOP/RESET switch to
the RUN position to place the CPU
module in the RUN status.
NO
Is the "ERR". LED
of the CPU module
on (flickering)?
Choose [Diagnostics]
on GX Developer or perform [PLC
Diagnostics] to check the error factor, and
remove the error factor.
NO
Boot operation
in TEST MODE?
To Section 11.3
End
Diagram 11.1 Flowchart for writing program
............
YES
[System Monitor]
YES
11.2 Procedure for writing program
Write to PLC screen
QSCPU User's Manual
(Hardware Design, Maintenance
and Inspection)
QSCPU User's Manual
(Hardware Design, Maintenance
and Inspection)
9
10
11
11
- 3
Advertisement
Table of Contents
