Table of Contents
Advertisement
CHAPTER9 EMC AND LOW VOLTAGE DIRECTIVES
9.1
Requirements for Conformance to EMC Directive
9.1.1
Standards relevant to the EMC Directive
9.1.2
Installation instructions for EMC Directive
9.1.3
Cables
9.1.4
Power Supply Module
9.1.5
Others
9.2
Requirement to Conform to the Low Voltage Directive
9.2.1
Standard applied for MELSEC-QS series PLC
9.2.2
MELSEC-QS series PLC selection
9.2.3
Power supply
9.2.4
Control panel
9.2.5
Grounding
9.2.6
External wiring
CHAPTER10 LOADING AND INSTALLATION
10.1
Calculating Heat Generation of PLC
10.2
Module Installation
10.2.1
Precaution on installation
10.2.2
Instructions for mounting the base unit
10.2.3
Installation and removal of module
10.3
Wiring
10.3.1
The precautions on the wiring
10.3.2
Connecting to the power supply module
CHAPTER11 MAINTENANCE AND INSPECTION
11.1
Daily Inspection
11.2
Periodic Inspection
11.3
Battery Life and Replacement Procedure
11.3.1
Battery lives of CPU modules
11.3.2
Replacement Procedure of the CPU Module Battery
11.4
When PLC Has been Stored without a Battery
11.5
When Battery Has Gone Flat during Storage of a PLC
CHAPTER12 TROUBLESHOOTING
12.1
Troubleshooting Basics
12.2
Troubleshooting Flowchart
12.2.1
Troubleshooting category flow
12.2.2
Flowchart for when the ERR terminal (negative logic) is off (opened)
12.2.3
Flowchart for when the "POWER" LED is off
12.2.4
When the "ALIVE" LED does not come on or is off
12.2.5
Flowchart for when the "RUN" LED is off
12.2.6
When the "RUN" LED is flashing
12.2.7
Flowchart for when the "ERR." LED is on/flashing
A
- 14
Advertisement
Table of Contents
