Configuring The Unit To Access The Lan - Panasonic DP-MB251CX Operating Instructions Manual

To correct a mistake
Press MFN or MEN to move the cursor to the incorrect
character, and make the correction.
R To erase all characters, press and hold MwN.
3.5.3 Your fax number
You can program your fax number so that it appears on
the top of each page sent.
1
MMENUN A MBNM1NM0NM3N A MSETN
2
Enter your fax number, up to 20 digits.
R To enter a "+", press MGN.
R To enter a space, press MBN.
R To enter a hyphen, press MFLASHN.
R To erase a number, press MwN.
3
MSETN A MMENUN
To correct a mistake
Press MFN or MEN to move the cursor to the incorrect
number, and make the correction.
R To erase all numbers, press and hold MwN.
3.6 Configuring the unit to access
the LAN
You can use a computer connected to the LAN for some
features of this unit (printer, scanner, etc.). To enable
these features, you need to set the IP address, subnet
mask, and default gateway in the unit.
Important:
R Consult your network administrator when setting
the IP address, subnet mask, and default
gateway.
3.6.1 Setting up automatically with a DHCP
server
If your network administrator manages the network with
a DHCP (Dynamic Host Configuration Protocol) server,
it will automatically assign an IP (Internet Protocol)
address, subnet mask, and default gateway to the unit.
1
After connecting the LAN cable to the unit and the
computer, turn the power switch ON.
R The IP address, subnet mask, and default
gateway will be set automatically.
2
Install Multi-Function Station on the computer that
you want to use it with. See page 25 for details.
Note:
R You can connect two or more units and assign IP
addresses automatically with a DHCP server, but we
recommend assigning static IP addresses manually
for each unit to avoid network access and
configuration troubles.
3.6.2 Setting up manually
When your network administrator does not manage the
network with a DHCP server, you need to assign an IP
address, subnet mask, and default gateway manually.
1
MMENUN A MBNM5NM0NM0N A "DHCP"
2
M0N A "DISABLED" A MSETN
3
Set each item.
For the IP address:
1. M5NM0NM1N A "IP ADDRESS" A MSETN
2. Enter the IP address of the unit. A MSETN
For the subnet mask:
1. M5NM0NM2N A "SUBNET MASK" A MSETN
2. Enter the subnet mask of the network. A
MSETN
For the default gateway:
1. M5NM0NM3N A "DEFAULT GATEWAY" A MSETN
2. Enter the default gateway of the network. A
MSETN A MMENUN
4
Install Multi-Function Station on the computer that
you want to use it with. See page 25 for details.
3. Preparation
23