Panasonic DP-MB251CX Operating Instructions Manual page 26

3. Preparation
3
The [Connection Type] dialogue box appears.
For USB connection:
1. [Connect directly with a USB cable.] A
[Next]
R The [Connect Device] dialogue box will
appear.
2. Connect the unit to a computer with the USB
cable (A), then click [Next].
A
R If the unit is connected to your computer, the
model name will be automatically detected.
R You can change the name of the unit if
necessary.
3. Click [Install], then follow the on-screen
instructions.
R The files will be copied to your computer.
For LAN connection:
1. [Connect via the Network.] A [Next]
R The [Select a Network Device] dialogue box
will appear.
2. Check [Select from the search list] and select
the unit from the list.
R If the name of the desired unit is not displayed
on the list, and the IP address for the unit has
been assigned, check [Direct input] and
enter the IP address.
3. [Next]
R You can change the name of the unit if
necessary.
4. Click [Install], then follow the on-screen
instructions.
R The files will be copied to your computer.
26
Important notice
When installing using a USB cable connection, a
message may appear during the software installation.
This is normal and the software will not cause any
difficulties with your operating system. You can
continue the installation with no problem. This kind of
message is displayed:
R For Windows XP users
"The software you are installing for this hardware
has not passed Windows Logo testing to verify its
compatibility with Windows XP."
R For Windows Vista/Windows 7/Windows 8
users
"Would you like to install this device software?"
3.9.3 Wireless LAN connection
Note:
R It is recommended to connect the unit to the wireless
network before installation.
For information about configuring wireless LAN
settings, please refer to "3.7 Wireless LAN
settings", page 24.
If the unit has already been connected to the wireless
network
1. [Easy Installation (Wireless LAN)]
2. Select [Already set up wireless LAN].
R The installation will start automatically.
3. When the setup program starts, follow the on-screen
instructions.
R Easy Print Utility (page 39) and Device Monitor
(page 100) will also be installed.
4. The [Select a Network Device] dialogue box
appears.
1. Check [Select from the search list] and select
the unit from the list.
R If the name of the desired unit is not displayed
on the list, and the IP address for the unit has
been assigned, check [Direct input] and
enter the IP address.
2. [Next]
R You can change the name of the unit if
necessary.
3. Click [Install], then follow the on-screen
instructions.
R The files will be copied to your computer.
If the unit has not been connected to the wireless
network yet
1. [Easy Installation (Wireless LAN)]
2. Select [Not yet set up wireless LAN].
R The installation will start automatically.
Important:
R The USB cable is required for configuring
wireless LAN settings. Wireless LAN settings