Table of Contents
Advertisement
•
AGROUND
•
SIREN
3. Scroll through the menu to select a fog horn, then press ENT to start the fog horn sounding.
The fog horn will sound automatically until you press EXIT to cancel it. When the fog horn is not
sounding, it is in LISTEN mode.
4. To change the volume, turn the Channel Select knob OR press + or – when the fog horn is
sounding.
Note: you cannot change the volume of the HORN or SIREN.
2.11 NAV (Show Waypoint)
If a waypoint is already selected, the bearing and distance to the waypoint, and any cross track error,
are shown on the bottom line of the LCD.
Hold down NAV to enter NAVIGATION mode and show these details:
NEED BETTER SCREENSHOT
To quit NAVIGATION mode, you must reset the radio. See Section 3.8.
If you are in NAVIGATION mode and want to scan all the VHF channels while staying in NAVIGATION
mode, just hold down SCAN. Press SCAN to quit scanning.
To select a favorite channel, use the 3CH key. See Section 2.16.
2.12 GO (Reset the Cross Track Error)
Press GO if you are navigating to a waypoint and want to reset the cross track error. This is a VERY
useful single keystroke feature to use if you wander a little off-course but want to continue to your
active waypoint.
The bearing and distance to the waypoint, and any cross track error, are shown on the bottom line of
the LCD.
2.13 MOB (Man Overboard)
Man Overboard. Hold down MOB until the radio automatically enters NAVIGATION mode, saves your
current latitude and longitude as the MOB waypoint and immediately sets this position as the
destination waypoint.
You will see the following sequence of LCDs:
Hold 3 Sec
For MOB
Release To
Save
The bearing and distance to the Man Overboard position, and any cross track error (XTE), are shown
on the bottom line of the LCD.
To cancel MOB, select another waypoint.
Hold 2 Sec
For MOB
Release To
Save
Hold 1 Sec
For MOB
Release To
Save
11
M O B
B : 0 1 0 °
D : 0 . 0 1 nm
X : 0 . 0 0
Advertisement
Table of Contents
