Table of Contents
Advertisement
www.ti.com
4.2.11.2
OUT0 and OUT1 Independent Control:
The LMH0318 allows independent control of OUT0 and OUT1. Note: 0x09[5] over-ride effects both OUT0
and OUT1.
4.2.11.2.1 OUT0 10 MHz Clock
RAW FF
04
RAW 09
20
RAW 1C
20
4.2.11.2.2 OUT0 RAW Data
RAW FF
04
RAW 09
20
RAW 1C
40
4.2.11.2.3 OUT0 Mute
RAW FF
04
RAW 09
20
RAW 1C
00
4.2.11.2.4 OUT0 Reclocked Data
RAW FF
04
RAW 09
20
RAW 1C
80
4.2.11.2.5 OUT1 RAW Data
RAW FF
04
RAW 09
20
RAW 1E
00
4.2.11.2.6 OUT1 Mute
When OUT1 is muted, the differential peak-to-peak output voltage is approximately 0 V.
RAW FF
04
RAW 09
20
RAW 1E
E0
SNLU183 – September 2015
Submit Documentation Feedback
07
//Select Channel Registers
20
//Enable Over-ride
F0
//10MHz on OUT0
07
//Select Channel Registers
20
//Enable over-ride
E0
//OUT0 Raw Data
07
//Select Channel Registers
20
//Enable Over-ride
E0
//Set to 0: Mute OUT0
07
//Select Channel Registers
20
//Enable Over-ride
E0
//OUT0 Reclocked Data (valid only in locked condition)
07
//Select Channel Registers
20
//Enable Over-ride to control this setting with registers
E0
//OUT1 RAW Data
07
//Select Channel Registers
20
//Enable over-ride to control with registers
E0
//Set to 0: Mute OUT1
Copyright © 2015, Texas Instruments Incorporated
Device Configuration
LMH0318 Programming Guide
15
Advertisement
Table of Contents
