Advertisement

Quick Links

www.ti.com
User's Guide
LMR38020QEVM User Guide
The
LM38020QEVM
is a 80-V DC/DC buck regulator that employs synchronous rectification to achieve high
conversion efficiency in a small footprint. The EVM operates over a wide input voltage range of 6 V to 80 V to
provide a regulated 5-V output at 400-kHz switching frequency. The output voltage has better than 1.5% setpoint
accuracy and is adjustable using an external resistor divider. The module design uses the LMR38020S-Q1
synchronous buck converter with the following:
Wide input voltage (wide V
Wide duty-cycle range
Integrated high-side and low-side power MOSFETs
Cycle-by-cycle overcurrent protection
Spread spectrum
The LMR38020S-Q1 converter is available in an 8-pin SO PowerPAD
component count DC/DC solutions. The LMR38020QEVM evaluation module is qualified for the LMR38020-Q1
as well as the LMR38020 buck converter. See
CONVERTER
U1
1 General TI High Voltage Evaluation User Safety Guidelines..............................................................................................
2 LMR38020-Q1 Evaluation Module.........................................................................................................................................
Procedure........................................................................................................................................................4
2.2 Detailed Descriptions.........................................................................................................................................................
3
Schematic................................................................................................................................................................................7
Layout..............................................................................................................................................................................8
Materials......................................................................................................................................................................11
Figure 3-1. LMR38020QEVM Schematic....................................................................................................................................
Figure 4-1. Top Layer and Silkscreen Layer................................................................................................................................
Figure 4-2. Mid-Layer 1 Ground Plane........................................................................................................................................
Figure 4-3. Mid-Layer 2 Routing..................................................................................................................................................
Routing..............................................................................................................................................10
Trademarks
PowerPAD
is a trademark of Texas Instruments.
All trademarks are the property of their respective owners.
SNVU817 - NOVEMBER 2021
Submit Document Feedback
ABSTRACT
) range
IN
Table 1-1

Table 1-1. Device and Package Configurations

IC
LMR38020-Q1
8-pin SO package with PowerPAD (4.89 mm × 3.90 mm)
LMR38020

Table of Contents

List of Figures
View.......................................................................................................................................4
List of Tables
Configurations...........................................................................................................................1
Materials.............................................................................................................................11
Copyright © 2021 Texas Instruments Incorporated
package to enable high-density, low-
for package information.
PACKAGE
Table of Contents
2
4
5
7
8
9
9
LMR38020QEVM User Guide
1

Advertisement

Table of Contents
loading

Summary of Contents for Texas Instruments LM38020QEVM

  • Page 1: Table Of Contents

    Table 5-1. LMR38020QEVM Bill of Materials..........................11 Trademarks PowerPAD ™ is a trademark of Texas Instruments. All trademarks are the property of their respective owners. SNVU817 – NOVEMBER 2021 LMR38020QEVM User Guide Submit Document Feedback Copyright © 2021 Texas Instruments Incorporated...
  • Page 2: General Ti High Voltage Evaluation User Safety Guidelines

    WARNING: While the EVM is energized, never touch the EVM or its electrical circuits as they could be at high voltages capable of causing electrical shock hazard. LMR38020QEVM User Guide SNVU817 – NOVEMBER 2021 Submit Document Feedback Copyright © 2021 Texas Instruments Incorporated...
  • Page 3 High Voltage! Electric shock is possible when connecting board to live wire. Board should be handled with care by a professional. For safety, use of isolated test equipment with overvoltage and overcurrent protection is highly recommended. SNVU817 – NOVEMBER 2021 LMR38020QEVM User Guide Submit Document Feedback Copyright © 2021 Texas Instruments Incorporated...
  • Page 4: Lmr38020-Q1 Evaluation Module

    5. Monitor the output voltage while increasing the load current to 2-A maximum. Figure 2-1 for the location of the connectors. Figure 2-1. LMR38020QEVM Top View WARNING Hot surface! Contact may cause burns. Do not touch! LMR38020QEVM User Guide SNVU817 – NOVEMBER 2021 Submit Document Feedback Copyright © 2021 Texas Instruments Incorporated...
  • Page 5: Detailed Descriptions

    , of 115 KΩ. Refer to the External UVLO section of the LMR38020-Q1 SIMPLE SWITCHER® 4.2-V to 80-V, 2-A Synchronous Buck Converter Data Sheet for more detailed application information. PWRGD Power-good indication (J1) SNVU817 – NOVEMBER 2021 LMR38020QEVM User Guide Submit Document Feedback Copyright © 2021 Texas Instruments Incorporated...
  • Page 6 J6 PIN-2 (VO_S) is connected to the output for output voltage sensing and efficiency measurement. PIN-1 (V ) is connected to the noise injection resistor R3. The loop response can be measured on J6. LMR38020QEVM User Guide SNVU817 – NOVEMBER 2021 Submit Document Feedback Copyright © 2021 Texas Instruments Incorporated...
  • Page 7: Schematic

    Schematic 3 Schematic Figure 3-1. LMR38020QEVM Schematic SNVU817 – NOVEMBER 2021 LMR38020QEVM User Guide Submit Document Feedback Copyright © 2021 Texas Instruments Incorporated...
  • Page 8: Pcb Layout

    Test points have been provided for ease of use to connect the power supply, required load, and to monitor critical signals. Figure 4-1. Top Layer and Silkscreen Layer LMR38020QEVM User Guide SNVU817 – NOVEMBER 2021 Submit Document Feedback Copyright © 2021 Texas Instruments Incorporated...
  • Page 9: Figure 4-2. Mid-Layer 1 Ground Plane

    PCB Layout Figure 4-2. Mid-Layer 1 Ground Plane Figure 4-3. Mid-Layer 2 Routing SNVU817 – NOVEMBER 2021 LMR38020QEVM User Guide Submit Document Feedback Copyright © 2021 Texas Instruments Incorporated...
  • Page 10: Figure 4-4. Bottom Layer Routing

    PCB Layout www.ti.com Figure 4-4. Bottom Layer Routing LMR38020QEVM User Guide SNVU817 – NOVEMBER 2021 Submit Document Feedback Copyright © 2021 Texas Instruments Incorporated...
  • Page 11: Bill Of Materials

    Test Lead clips and hooks, SMT S1751-46 Harwin TP2, TP3 Test Point, Multipurpose, Black, TH 5011 Keystone 80-V, Low I Synchronous Buck Converter LMR38020SQDDARQ1 SNVU817 – NOVEMBER 2021 LMR38020QEVM User Guide Submit Document Feedback Copyright © 2021 Texas Instruments Incorporated...
  • Page 12 STANDARD TERMS FOR EVALUATION MODULES Delivery: TI delivers TI evaluation boards, kits, or modules, including any accompanying demonstration software, components, and/or documentation which may be provided together or separately (collectively, an “EVM” or “EVMs”) to the User (“User”) in accordance with the terms set forth herein.
  • Page 13 www.ti.com Regulatory Notices: 3.1 United States 3.1.1 Notice applicable to EVMs not FCC-Approved: FCC NOTICE: This kit is designed to allow product developers to evaluate electronic components, circuitry, or software associated with the kit to determine whether to incorporate such items in a finished product and software developers to write software applications for use with the end product.
  • Page 14 www.ti.com Concernant les EVMs avec antennes détachables Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à...
  • Page 15 www.ti.com EVM Use Restrictions and Warnings: 4.1 EVMS ARE NOT FOR USE IN FUNCTIONAL SAFETY AND/OR SAFETY CRITICAL EVALUATIONS, INCLUDING BUT NOT LIMITED TO EVALUATIONS OF LIFE SUPPORT APPLICATIONS. 4.2 User must read and apply the user guide and other available documentation provided by TI regarding the EVM prior to handling or using the EVM, including without limitation any warning or restriction notices.
  • Page 16 Notwithstanding the foregoing, any judgment may be enforced in any United States or foreign court, and TI may seek injunctive relief in any United States or foreign court. Mailing Address: Texas Instruments, Post Office Box 655303, Dallas, Texas 75265 Copyright © 2019, Texas Instruments Incorporated...
  • Page 17 TI products. TI’s provision of these resources does not expand or otherwise alter TI’s applicable warranties or warranty disclaimers for TI products. TI objects to and rejects any additional or different terms you may have proposed. IMPORTANT NOTICE Mailing Address: Texas Instruments, Post Office Box 655303, Dallas, Texas 75265 Copyright © 2021, Texas Instruments Incorporated...
  • Page 18 Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Texas Instruments LMR38020QEVM...

This manual is also suitable for:

Lmr38020s-q1

Table of Contents