St1Y16-Tpe3 Transistor Output Module With Protective Functions (Source Type) - Mitsubishi MELESEC-ST User Manual

7 I/O MODULES

7.2.5 ST1Y16-TPE3 transistor output module with protective functions (source type)

Specifications
Number of occupied slice
modules
Number of occupied I/O points
Number of output points
Isolation method
Rated load voltage
Maximum load current
Maximum inrush current
Leakage current at OFF
Maximum voltage drop at ON
OFF to ON
Response time
ON to OFF
Surge suppressor
Protection function
Wiring method for common
Dielectric withstand voltage
Insulation resistance
Noise durability
Protection of degree
Operating status
Available base module
Available coding element
5VDC internal current
consumption
Weight
7 - 10
Type
• Yes (thermal protection, short circuit protection)
• Indicated by LED (When protective function is activated, ERR. LED turns on and signal is
output to head module)
• Automatic recovery
10M or larger by insulation resistance tester across DC external terminals and FG
By noise simulator of 500Vp-p noise voltage, 1
Spring clamp type
Screw clamp type
ST1A-CKY-08 (orange) (factory-fit) Refer to Chapter 8 for details.
ST1Y16
-TPE3
RUN
ERR.
11 21 31 41 51
Transistor Output Module (source type)
ST1Y16-TPE3
CC-Link: 0 point for input, 16 points for output
PROFIBUS-DP: 16 points for each of input and output
16 points
Photocoupler
24VDC (+20/-15%, ripple ratio within 5%)
1.0A/point, 4A/common
2A, 10ms or less
0.3mA or less
0.15VDC (TYP.) 1.0A, 0.25VDC (MAX.) 1.0A
0.5ms or less
1.5ms or less (rated load, resistive load)
Zener diode
2 points/common
560VAC rms/3 cycles (altitude 2000m (6557.38ft.))
and 25 to 60Hz noise frequency
First transient noise IEC61000-4-4: 1kV (bundle)
IP20
ON indication (LED)
ST1B-S3Y16 2-wire type + shield
ST1B-E3X16 2-wire type + shield
0.160A (TYP. all points ON)
0.11kg
Appearance
61 71 81 91 101 111
8
s noise width
121 131 141 151 161
MELSEC-ST
7 - 10