Base Module; Base Module Specifications - Mitsubishi MELESEC-ST User Manual

6 BASE MODULE

6 BASE MODULE

6.1 Base Module Specifications

Item
Applicable wire size
Wire type
Installation
Weight
Terminal block type
Spring clamp type
6
Screw clamp type
6 - 1
The base module specifications are indicated below.
Spring clamp type
1-slot width
Twisted wire: 0.5 to 1.5mm
When bar crimping terminal is used: 0.5 to 1.5mm
Model
ST1B-S4X2
ST1B-S6X4
ST1B-S3Y2
ST1B-S4IR2
ST1B-S4X16
ST1B-S3Y16
ST1B-S4P2-H-SET
ST1B-S4P2-R-SET
ST1B-S4P2-D
ST1B-E4X2
ST1B-E6X4
ST1B-E3Y2
ST1B-E4IR2
ST1B-E4X16
ST1B-E3Y16
ST1B-E4P2-H-SET
ST1B-E4P2-R-SET
ST1B-E4P2-D
Use the ST1B- 4P2-H-SET or ST1B- 4P2-R-SET by combining two base modules
of 1-slot width. The specifications are the same as those of the 1-slot width.
Specifications
8-slot width
2
Solid wire: 0.5 to 2.5mm (AWG 20 to AWG 12)
2
(AWG 20 to AWG 16)
2 to 4-wire type
Direct installation to DIN rail
Refer to following table
MELSEC-ST
Screw clamp type
1-slot width 8-slot width
2
(AWG 20 to AWG 16)
Weight
0.04kg
0.05kg
0.03kg
0.04kg
0.23kg
0.21kg
0.07kg
0.07kg
0.04kg
0.05kg
0.07kg
0.04kg
0.06kg
0.33kg
0.29kg
0.10kg
0.10kg
0.05kg
6 - 1